[xsboost90]

i repaired a friend of mines 911 years back- who had a full respray done. They took the car to bare metal and then primered and sprayed the car- looked good. They did not etch primer the car. His car was a track car and basically every rock chip went to bare metal and started to rust. I fixed a damaged fender and resprayed the entire front clip- that was where most of the chips were- and afterwards the car when i chipped just would go to the first layer of primer. Bare metal should go to etch primer, finish bodywork, then a filler primer, sealer and paint. I usually dont seal but its good to do.