|
Registered
Join Date: Jul 2012
Location: Simi Valley, Ca.
Posts: 265
|
Warped rotors
Why not buy a small dial indicator with a magnetic base and check the rotor. First try and rock the rotor in and out at the point your dial indicator touches the rotor (somewhere close to the last 10mm of wear surface on the perimeter) to see if you need to tighten the wheel bearing nuts. Next rotate the rotor to see if there is any variation in the reading with a complete 360 turn of the rotor. Not sure what would be acceptable, but anything more than 10 or 15 thou. probably is not good.
Bob B
|