I have a 2.8 with 46 IDA carbs and I have not run it for at least 5 years .I was going to send it out to be refreshed but decided not to.I removed the engine this week and have torn it down to bare block. I was able to prime the oil system and roll it over by hand so I don't have to worry about spun bearings . Next step is to replace a few hoses that have cracks in the oil lines and to check valve clearances and solid chain tensioners .I would like to find out if it is possible to remove engine oil cooler and replace it with a blanking plate . I have a huge oil cooler for the front of the car so it is really not needed . Also can I buy a partial gasket set for the engine or do I have to buy the whole kit....Thxs
