|
Just measured.. Appx 7.3 mm thick at the thinnest part of the crown, or about 0.287 in. So not as much material to play with.
And after some crude measuring and math, maybe as little as .10 or .15 mm milled off the top might get me where i need to be. I will call JE perhaps and see if that will get me perilously thin or if its ok to do that. Can I use the specific gravity of aluminum to tell me how much I have taken off, or do I have to measure their volume several times as I machine them? Hmm.
Last edited by IXjamesXI; 03-04-2014 at 03:29 PM..
|