Did a little bit more work on the 2000 kilo paper weight. I checked the speed and reference sensors how clarks garage did it, heres a link to what I used as references
Speed and Reference Sensors - Checking, Replacement, and Adjustment. Any ways, what I did is I checked the resistance through each of the terminals how clarks garage showed.
Speed Sensor
terminal 8 - 27 measured 300 ohms
terminal 8 - 23 measured 0.8 M ohms
Refernce Sensor
terminal 25 - 26 measure 1300 ohms
terminal 25 - 78 measure 0.6 M ohms
I wish I had an oscilloscope though to check the voltage waves.
I also grabbed a test light to check the ignition coil. When I turned the key to the on state, It lit up. When I started to crank, the light flickered lightly and not very quickly.
Does this mean that my sensors are bad, I am still going to order some new ones just in case, plus wont harm having a spare set.
Plus I dont know if this means anything but the first time i did start my car, it ran for about 3 seconds then died. Did the same thing again a couple days later but ran for 10 seconds this time.