[jedwards1123]

I am currently restoring a RHD 1971T and I was away when my mechanic stripped the car down so it could go off for panel and paint. As a result, I did not get the chance to take lots of photos of how the wiring harness sits in the car.

I was planning to check and re-bind the harness in readiness for installation, but don't known anything about where it goes and in which direction the various branches in harness go.

Ideally, I'd love to see a picture of a full harness laid out on the ground much like it would sit in the car.

Can anyone help? I can read a circuit diagram and can replace any worn bits, and rebind, but without knowing how it all fits together, its hard.