[eimkeith]

Originally Posted by ajserrano

Very nice Keith, what are you planning to do about bearings? I actually have four castings of these pieces floating around since 2004? BTW, I believe my machinist took measurements of the original RSR parts I had and I was supposed to look for the correct bearings, never did. I may have to follow through with that eventually...

Great job, no less from pictures. Wow!

Here you go!

OUTSTANDING!

That is the only reference to the inside of these that I've seen! Was there also a component located in the chassis side?

I set our part up to use Rebel S Racing 's igus-based bushing kit, but could also likely configure it to use the Elephant part.

I also put an o-ringed socket under the cap to keep water out, so that is different than the original part in that respect also.

Thanks for the additional photos!


keith.

(sent from my rotary dial phone.)