|
|
|
|
| Author |
|
|
Registered
|
Upside
New rebuild! it appears I installed the Pistons upside down. Should I just rotate them or pull them out of the cylinders and start over with the proper ring orientation.
|
||
09-23-2018, 05:58 AM
|
|
|
Registered
Join Date: Oct 2008
Location: Nash County, NC.
Posts: 8,492
|
Ring orientation doesn’t matter as they will move to their desired location almost immediately.
Bruce |
||
|
09-23-2018, 09:46 AM
|
|
|
Registered
|
So I'm going to remove the clips and piston pins and rotate piston in the cylinder 180 and reinstall pin and clip does that sound right ?
|
||
|
09-24-2018, 11:21 AM
|
|
|
Registered
Join Date: Apr 2016
Posts: 1,176
|
IMHO Ring orientation does matter; on the flat 6 motor you never want ring gaps pointed straight downward as that contributes to even more oil pooling in the cylinders when left for a long time, and even more smoke than usual on startup.
|
||
|
09-24-2018, 11:30 AM
|
|
|
Registered
Join Date: Jul 2001
Location: Portland Oregon
Posts: 7,007
|
If your engine uses offset piston pins, you really need to R&I them correctly.
__________________
Steve Weiner Rennsport Systems Portland Oregon (503) 244-0990 porsche@rennsportsystems.com www.rennsportsystems.com |
||
|
09-24-2018, 12:40 PM
|
|
|
Registered
|
1977 2.7 cis engine with euro Pistons I don't think they are offset. If I pull the piston out will I damage the rings or is there a trick involved? I hate to buy new rings they were hard to fit and required a different size for the center gap!
|
||
|
09-24-2018, 03:52 PM
|
|
|
