|
|
|
|
| Author |
|
|
Wo ist die Rennstrecke?
Join Date: Mar 2004
Location: St Johns, FL
Posts: 1,210
|
Rear Main Seal
When mating the case halves, the only problem (I hope) was that the ream main seal kept creeping out. I used Curil T and even tapped it back in a couple times, but 10 min later it was out. This is a 79 930 case.
Suggestions? I think after all the tapping, I will need to get another seal. Its a bit, ah.. contorted. On a bright note, there was a perfect beed of orange all around the center of the case as I torqued the case-through's and nuts. |
||
11-06-2004, 06:48 AM
|
|
|
Registered
Join Date: Apr 2003
Location: Carnation, WA
Posts: 623
|
Definately pull it out and replace it, make sure you clean the orange 574 from this area before putting in a new one. I believe this is why mine leaked... the orange 574 pushed against the edge of the seal at the case seam.
__________________
David |
||
|
11-06-2004, 07:42 AM
|
|
|
Registered
Join Date: Mar 2001
Location: Marysville Wa.
Posts: 22,435
|
i put them in dry. dry, as in hole wiped clean and no goober on the outside of the seal.
__________________
https://www.instagram.com/johnwalker8704 8009 103rd pl ne Marysville Wa 98270 206 637 4071 |
||
|
11-06-2004, 01:53 PM
|
|
