964 cam pitting - advice?

[Axel84]

My 964 cams look reusable except for this pitting on the right camshafts cyl 4-6. What is the opinion here . Reusable / needs regrind?

[AVI_8]

Not reusable, and you’ll need new or regound rockers to go with the new/re ground cam.

[Axel84]

Thanks!

[AVI_8]

I can’t help but notice the wear marks on your cam bearing surface, that may give an indication as to the general wear on your entire engine, it doesn’t look great to be honest. There’s been a lot of crap running around that engine and if it’s scored a hardened cam surface you can only imagine what lies within the crank bearings.

[Mr. Merk]

Send an email to John

https://www.drcamshafts.com/

[mepstein]

If you can feel it with your fingernail, it’s not good.

[AVI_8]

Originally Posted by mepstein

If you can feel it with your fingernail, it’s not good.

Fair enough but your eyes also don’t tell lies

[Axel84]

Originally Posted by AVI_8

I can’t help but notice the wear marks on your cam bearing surface, that may give an indication as to the general wear on your entire engine, it doesn’t look great to be honest. There’s been a lot of crap running around that engine and if it’s scored a hardened cam surface you can only imagine what lies within the crank bearings.

Yeah Im changing the crank too .
full split

[Jeff Alton]

Originally Posted by Mr. Merk

Send an email to John

https://www.drcamshafts.com/

Yes, John will take care of you.


Cheers

[safe]

check and clean the spraybar too.

[stownsen914]

Clean everything