|
|
|
|
| Author |
|
|
Registered
|
Where to buy Rod, Chain Holder & 10 mm headbold remover
Hello
I was looking through "Waynes World" 911 How to rebuild Book, and could find the 10mm Snap On Stud remover in his store. I donīt what to leave any extract marks on the studs, thats why I like the snap on version which clamps the thread. What is the tightening torgue for the new divilar studs? Please post the value in Nm. As well as the rod & chain holder. He mentioned they cost about 25 $. Donīt want to make it for that price. Who knows where to buy? Regards RW Last edited by HKZ Bob; 07-29-2007 at 01:06 AM.. Reason: mistaken cam & rod |
||
07-29-2007, 01:01 AM
|
|
|
Registered
Join Date: Jul 2001
Location: mt. vernon Wa. USA
Posts: 8,744
|
RW,
I don't believe that there is a torque spec for the headstuds. They should install without much resistance and are installed to a height spec of 135mm length above the case. I.E. installation height from the case to the top of the stud should measure 135mm. Loctite 271 is used as a threadlocker. (refer to pages 136 & 137 of waynes rebuild book. regards, al
__________________
[B]Current projects: 69-911.5, Previous:73 911X (off to SanFrancisco/racing in Germany).77 911S (NY), 71E (France/Corsica), 66-912 ( France), 1970 914X (Wisconsin) 76 911S roller..off to Florida/Germany RGruppe #669 http://www.x-faktory.com/ |
||
|
07-29-2007, 10:07 AM
|
|
