Pelican Parts Forums
Page 4 of 4 « First « Prev 2 3 4
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   911 Engine Rebuilding Forum (http://forums.pelicanparts.com/911-engine-rebuilding-forum/)
-   -   Rick's engine rebuild starts in Cleveland (http://forums.pelicanparts.com/911-engine-rebuilding-forum/383835-ricks-engine-rebuild-starts-cleveland.html)

Rick Chip 11-09-2010 03:54 AM
Hi Francisco,

There was no machining needed on my engine, they fit right in.

Good Luck.

sjf911 11-10-2010 11:41 AM
Quote:
Originally Posted by Rick Chip (Post 5663520)
Hi Francisco,

There was no machining needed on my engine, they fit right in.

Good Luck.
Just to completely clarify, these are placed on the stock cylinders (flat surface) without any pre-existing machined groove for them on the head or cylinder, correct?

pirin911 11-11-2010 09:32 AM
Thanks Rick.

Francisco

lvporschepilot 11-11-2010 01:53 PM
Any turbo lag? No doubt that little gem is uber quick


All times are GMT -8. The time now is 05:22 AM.
Page 4 of 4 « First « Prev 2 3 4
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.