|
|
|
|
| Author |
|
|
Registered User
Join Date: Jan 2013
Location: Grapevine, TX
Posts: 214
|
Can this be fixed?
My build has not gone to good in the last couple of days. Mainly, due to my mistakes. Decided to disassemble case because I wasn't happy with the way it went. Found this at inboard main bearing boss. Stud must have gouged the side. I was so concerned about the oil seals getting pinched, I didn't look as close as I should have to that stud.
 Can this be fixed? Just in front of where the bearing sits. |
||
12-27-2013, 05:49 PM
|
|
|
Registered
Join Date: Oct 2008
Location: Nash County, NC.
Posts: 8,473
|
No need, it is just open metal and doesnt support the bearing and the intermediate cap covers it. Work with what you have.
Bruce |
||
|
12-28-2013, 04:31 AM
|
|
|
abit off center
|
Just take off the high spots.
__________________
______________________ Craig G2Performance Twinplug, head work, case savers, rockers arms, etc. |
||
|
12-28-2013, 05:05 AM
|
|
1969 and 1986 Porsche Targa and Coupe 1720cc and 3
