Pelican Parts Forums
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   911 Engine Rebuilding Forum (http://forums.pelicanparts.com/911-engine-rebuilding-forum/)
-   -   Before your newbie rebuild, did you buy every tool you needed? (http://forums.pelicanparts.com/911-engine-rebuilding-forum/863741-before-your-newbie-rebuild-did-you-buy-every-tool-you-needed.html)

Speed Buggy 06-03-2015 07:34 AM
I also use a leftover 13mm wrench as a flywheel lock, even easier and faster than drilling bar stock ;)[/QUOTE]

Yep, Mike, I've done that too. Works great.

Walt Fricke 06-03-2015 07:37 PM
I like a 10mm wrench - tighter fit.

michael lang 06-03-2015 11:35 PM
Quote:
Originally Posted by whiz05403 (Post 8609580)
Get the more expensive "tapered" ring compressor that's specific for your cylinders. Much better than the "squeeze" types.
I did, I bought the Hazet tool. I researched and shopped for a week trying to decide which tool was the best to use then another 2-3 days deciding where to buy the damn thing. I looked and looked but any way you looked at it, the tool was going to be $200-225 depending on where you purchased it and then another almost week waiting for the stupid thing to arrive. That's just one example.


All times are GMT -8. The time now is 03:23 AM.
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.