|
|
|
|
| Author |
|
|
Registered
Join Date: Mar 2003
Posts: 231
|
I.D. part
hi guys,need help with this part.It goes on my '69 2.0 at the end of the air channel on the shroud.It's a piece of sheet metal about 5.5" x 3.5" x 1mm thk. With a right angle bend along its length 1/2" wide. It was riveted on with 3 rivets.I know it goes on right above the oil cooler but I can't figure out the orientation.Any help greatly appreciated.thanks,T.C.
|
||
05-19-2015, 06:29 PM
|
|
|
911 2.2 T targa
Join Date: Jun 2012
Location: Netherlands
Posts: 89
|
The piece should line up with the edge of the oil-cooler right next to the nr.6 cylinder. I think the bended edge then is pointing in the direction of the rear of the car. This picture I found on Ebay. The metal is bended but you can see the orientation of the edge.
Last edited by Heinz911; 05-20-2015 at 01:28 AM.. |
||
|
05-20-2015, 01:22 AM
|
|
|
Registered
Join Date: Mar 2003
Posts: 231
|
Thank you so much Heinz911!
|
||
|
05-20-2015, 09:38 AM
|
|
