Some updates from the past week
Crank pulley installed, 77 case requires grind by the left side of the puller for the sensor. Also had to shave some of the bottom of the fan housing.
Cam shaft sensor required a bit of machine work, Richard @clewett was able to take of that for us, thank you for the continued support. Bolt tapped and in place.
Wires wires wires.... Decided to move the tec gt unit under the passenger seat. Spliced the existing harness to extend a bit. Was trying to locate a longer ecu to dfu cable, ended up finding a 6ft one on the electromotive site and will add in.
Getting closer. CHT also tapped and installed over cylinder 4.
Next up, need to source connectors for existing fuel lines to the filter and for the return from the an fittings.