Quote:
Originally Posted by Techno Duck
The drivers side mount is not fully seated in the cross member. A section of the rubber mount should tuck into the recess on the aluminum crossmember. This is why the rubber mount does not line up with the engine leg.
Compare how your passenger side mount (which is correctly seated in the crossmember) looks compared to the drivers side.
|
i have the drivers side in the notch. both are fully seated.
the engine is lifted using an engine support bar from the strut towers. i already tried mounting both mounts on the engine, and then pushing the cross-member into place, and the same 1/2 inch alignment problem was there.
1/2 inch is far to large a gap to prybar. maybe a few mm, even a 1/4 inch, but the mount simply doesn't have the motion required to both fit the engine mounting holes, and the cross member hole.