|
like with every thing it's has to start with the 1st steps . in this case it starts with the fitment of the pieces being welded in then 2nd the quality of the welds your doing . if your welds are not good and your getting distortion and warping from your welds you need to 1st learn how to weld with out getting warping and distortion in the panel . again it starts on the 1st steps and carries on thru the rest of the job to the quality of the job at the end .
i hate to sound like an ass or bragging but i don't tend to need any fillers over my patch work if i do it's only a very tight skim coat and i will spray a coat or two of a E-primer down 1st then do my filler work over it . the E-primer should be all that is needed to prevent any rust .
|