|
I thought that was the case but in reading through the rebuild procedure in one of the Porsche tech articles it mentioned marking the length position of the rack before removing the pinion and I was trying to make sense of that.
Also. My prior tie rod ends were off set quite a bit differently from one another. I marked those measurements. Should I keep those the same when reinstalling or should I make them even.
My plan was to install and then take to have aligned so I know this will only be temporary but it needs to be close to drive to shop.
If the rack is perfectly centered in the car, why would the measurements for the tie rod ends be different by more than a cm from the previous alignment?
|