Quote:
Originally Posted by Trakrat
I don't understand how this yoke can really hold the weight of the engine with just 2 bolts.
I took out the 2 studs and put in two 2 bolts... probably threaded an inch into the engine block with the yoke on it.
I'm amazed that this entire engine can be held on by just 2 bolts on the yoke and engine stand.
Am I missing something or is that really all it takes???
Do I need to get certain bolts to hold it? I just picked up a couple M10 x 1.5 bolts from my local hardware store.
|
I usually leave the long stud, slip a pipe over it, and the a nut/washer and tighten...
The bottom is just a bolt, don't over do it, you could probably crack the case...
Holding the motor upright, or with the drivers side up is pretty strong as the yoke cradles it...
Drivers side down, heaven forbid with all the ancillaries on, seems way more iffy based on geometry...