![]() |
Quote:
|
I think a .22 will need a follow up shot from a larger caliber to finish him off.
I'd definitely not put out snares unless you want your dog to be Purina Coyote Chow. |
I was told by an old country guy that he hangs a shark hook by a wire about 3ft off of the ground with Vienna sausage as bait. Cruel but effective.
|
Quote:
Here's a close up after he quit shaking it. The pic second pic is after he tree'd a bobcat. http://forums.pelicanparts.com/uploa...1426119813.jpg http://forums.pelicanparts.com/uploa...1426119834.jpg |
I used to have one hell of a good time hunting coyotes in Eastern Washington, and I was able to make a fair bit change off the deal as well. We used to get anywhere from $50 to $150 a pelt for the darn things. I think a guy would be lucky to see $10-$20 today.
We used to use simple little mouth-blown calls like the two shown below. These are your classic "dying rabbit" calls. The black, bulb shaped one is just like a squeaky toy - you squeeze it to make it squeal. We would tape these to the forearm of our rifles and use them if any 'yotes were getting in real close. While there were early, somewhat crude electronic calls available back then, we always thought that was cheating. http://forums.pelicanparts.com/uploa...1426120858.jpg I started out shooting them with my old M70 '06, loaded with 110 grain bullets. I soon got tired of patching hides from the exit wounds, and Remington came out with their saboted .22 caliber bullets in '06 cases - the Remington Accelerator round. I used those for awhile, and they worked great, but this looked like a good excuse for another rifle... So I bought a Ruger #1 in .220 Swift. I used that for years, until I shot the throat out of the original barrel. It loved 53 grain Sierras and Reloder 15, approaching 4,000 fps with that combination. After the barrel was shot out to the point I could no longer seat bullets out far enough to almost touch the rifling, it sat for a couple of years. Then, on our 10th anniversary, my lovely wife (no doubt with a bit of input from some shooting buddies) stole it and had Rick Freudenburg re-barrel it with a 28" stainless 1:12" twist Lilja barrel. That's how it remains today. Its new favorite load includes the 60 grain V-Max over a case full of IMR4350, for about 3,750 fps. Absolute death on coyotes as far away as you can make them out. http://forums.pelicanparts.com/uploa...1426120904.jpg So, Hugh, I believe Remington still makes that Accelerator load in a number of calibers, including .30-30. Might be just the ticket to "reach out and touch someone" if they start getting shy and staying out of .30-30 range. |
Quote:
|
Craig..i just googled that breed. AMAZING!!
i think my good friend, a Mastiff (english?) guy was talking about this breed. he described TANK perfectly. if i ever get a ranch property of my dreams, i am getting one of those!! |
Out where my other house is if you don't shoot them you are a bad neighbour (cattle country). Destructive little beasts. If they have targeted your dog they will keep at it till they get him. Pick up a rabbit call and one of these: Sharpshooter Blind, Realtree Xtra - Walmart.com
Go set up where you have a clear view around you and hammer them. |
Quote:
|
Colorado Fur auction
Coyote – $40.74 average, with 1614 sold. February 2015 |
I'm not a big gun guy, although I own a few, and right now I'm traveling for work, so I couldn't tell you squat about grains, loads,etc. I inherited the 30-30 lever action Marlin. It has a pretty well dialed in scope, and has a kick like a mule, and I'm sure it will do the job.
|
Quote:
Quote:
Quote:
|
A friend of mine lives out of town on a 1/4 section ranch. He raises Longhorns as a hobby. He has a few horses as well. He is far enough out the the low life city folks dump off unwanted dogs and cats. He get them spayed or neutered and feeds them has shelters for lots of dogs. On occasion he hears a lot of ruckus and it is usually a coyote. He goes to the attic window with his 270 and waits. After a few dead yotes that pack moves on.
|
.22 will kill a yote, but you need to knock them down with an accurate head shot, then polish them off. If one looks at crime statistics, a surprisingly large number of people killed with firearms are killed with .22s. It doesn't have the knock down power of a center fire rifle, but it still will put a hole in you. Given that we are basically a big bag of water, holes ain't good.
|
Quote:
Ask JFK if a .22 will kill a coyote. |
Quote:
Yes, lots of folks are murdered with .22's. Way different circumstances, though. Lots closer, element of surprise, multiple shots, etc. can all play into it. You'll never get that close to a live coyote, and even if you did, he's not just going to stand there unsuspecting and let you shoot him. Guys do kill them with shotguns, but they are expert callers, well camouflaged, and typically use full choked guns with heavy turkey loads. Even then, they are really stretching the range of that combination. |
As a kid, my choice was the bolt action .22. Still love it, and have it to this day. I would shoot jackrabbits with iron sights over 100' away. Even they would run away before dying. I would not really want to have a dying coyote walking around or with a flesh wound walking around. The preference is to blow him away comic book style, but that is often not the case, since shooting is an opportunistic undertaking. You don't always get a clean head shot either, so you want to make the first hole as big as possible.
|
This sounds like a good excuse to buy something in .338LM......I wonder what that round would do to something as small as a coyote??
|
I opt for .357 HPs (from a Marlin) over .22lr or more potent (30-30 et al) and my tenant chooses .45LC (lever) over everything else in his POTENT arsenal. Got to be quick & clean and shots are typically less than 50yds or so. Is that "my" best optiion? Noise doesn't matter...
|
Wow, three pages discussing weapons over this.
Get the fence repaired? |
All times are GMT -8. The time now is 03:41 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website