|
|
|
|
| Author |
|
|
Registered
Join Date: Oct 2008
Location: Nash County, NC.
Posts: 8,502
|
A engine block and internals
Offer withdrawn at this time but thanks for looking
Bruce Kind of out of the comfort zone here from 911 I have an A engine stamped 1600 on the centerline case, it doesnt have the 3rd piece. Stoddard web site says its 57 to 59 1600 normal. I have opened it, the bearings are all standard/ std. I can mike the rods and they are above minimum spec. The mains come under 50mm for accurate measuring, I dont have the smaller equipment to accurately measure under 50mm. No bearings are spun, crank is smooth Im selling all the pieces I dismanteled. Case, crank, rods, crank gears, and cam with drive gear. The case has the cam riders installed. I have the case in safety kleen to clean the basics. More photos, just ask $1000 OBO, FOB Raleigh/Rocky Mount, NC Thanks for looking Bruce Last edited by Flat6pac; 09-26-2014 at 03:24 AM.. |
||
09-09-2014, 08:42 AM
|
|
 |
| Thread Tools | |
| Rate This Thread | |
|
|
