![]() |
|
|
|
Registered
|
MFI Pump / partial load factory setting
I need to set my pump’s partial load / main rack adjustment back to a factory (or reasonable starting point) setting. I can’t seem to find any info in the factory manuals, CMA, or online, so any help would be appreciated.
__________________
'70 911S 1002938 '70 Ducati Mark 3D 350 |
||
![]() |
|
Registered
Join Date: Sep 2015
Location: Costa Rica and Pennsylvania U.S.
Posts: 3,301
|
initial adjust
Take your bottom adjustment and turn it all the way in.Then back it out 24 clicks and start.You need an AFR gauge to set the main rack.Ciao Fred
|
||
![]() |
|
Registered
|
Quote:
I’m able to test AFR, but was hoping for a starting point for my partial load as well. A PO had it set so far out that the adjustment screw fell into the sump with my first turn! I suspect it was messed with to address a whole host of other issues (bad injectors, sloppy throttle bodies, poorly adjusted linkage, etc) that have been addressed this winter.
__________________
'70 911S 1002938 '70 Ducati Mark 3D 350 |
||
![]() |
|