WEVO shifter thread size

[Harpo]

Good afternoon everyone,

Does anyone know the thread size & pitch for the top of the shifter where the shift knob threads on to? My guess is M14-1.5

Thanks

David

[speednme1]

Originally Posted by Harpo

Good afternoon everyone,

Does anyone know the thread size & pitch for the top of the shifter where the shift knob threads on to? My guess is M14-1.5

Thanks

David

should be an m6x1.00

[Harpo]

Definitely way bigger than M6. The major thread diameter is 13.76mm

Originally Posted by speednme1

should be an m6x1.00

[Harpo]

I want to install this but it has no internal threads. I'm hoping to install a Heli coil or time cert.

[speednme1]

You’re correct that is M14

[speednme1]

Originally Posted by Harpo

Definitely way bigger than M6. The major thread diameter is 13.76mm

Is there a thread inside that thread? As in the wevo pic (11)...can you open that knob or is it sealed ?

https://www.wevo.com/Products/ShifterProducts/ShifterImages/WEVO_915_Shifter_INSTRUCTIONS_2009.pdf

[Flojo]

The WEVO "modern" shift lever has a M6 thread inside.
When I got my Mahagoni custom made prototype 917-shiftknop I JB-welded a M6-hex-head screw inside.
works perfekt!

[Harpo]

Got my shift knob back from the machine shop with the M14-1.5 Heli coil installed inside. The ID of the shift knob was very close to the recommended drill size so no drilling was necessary just tapping with the specified tap and installation of the heli coil.