R tail lights in AND working.....
 

Woo hoo....
http://forums.pelicanparts.com/uploads/Rlights.jpg

Looks nice, I also like the Hannah Barbara "Carrera RS" script ya have going.........now dump that ricey exhaust and you'll be good to go =).

supertrapps aren't ricey as long as the cars performance backs it up :D

Mike, nice look..now where did you get all the parts? Bumper and all.

Bumper, GT racing...
R light kit, TRE......

Dave just sent me a note saying he was going to send me some bulbs....:D

Even with only 10w bulbs they seem pretty bright.

Sweet!

Where does the R Gruppe sticker go?

THAT is a rear end with attitude. :)

I don't think they would have me....:p

very nice mike! looking forward to having mine installed. can we get a close up of you mounting points?

Don't mind the dirt...it's been raining.

http://forums.pelicanparts.com/uploads/P6040002.JPG http://forums.pelicanparts.com/uploads/P6040003.JPG

Very cool, Mike. Damn! I should've asked Dave about them when I was at TRE on Thurs.

Damn! Damn! Damn!

Damn sweet, too! :)

Hey, I just noticed something - no back up lights...

Or is it not worth caring about?

Damn Mike...that looks great! I am glad I was able to capture the look of the ol gal before...now send me a pic of her all dressed up and I will do up another one for ya.

Is it just me or is that ducktail warped?.....

not warped...just not mounted quite perfect, as the left side rides a little higher at the lower edge. Still a very nice look...amazing what can be done with a little fiberglass.

It's not down and latched....I was excited and took a pic before I cleaned up everything.

Hey Mikez, I like it :p

Side note to Bob.....where there are two sheet screws, I had to add an angle iron on the inside so that screws had something to bite on. The screw on the outside towards the front of the car had sheet metal underneath.

Yeah, I mentioned that in an another thread....no one seemed too concerned. I have a red euro foglight that I may mount on the lower bumper and use that.....hmmm, wonder if it could do double duty with a single filament bulb......

Seems like a lot of trouble to go through to loose a few ounces only to slap in a peice of angle iron to mount it!

Looks great!