|
|
|
|
| Author |
|
|
Registered
|
Torque for 930 CV joint
I have been looking through the technical posts and I am trying to determine the correct torque for the CV bolts on a 930. What I have read is either 30 or 60 ft-lbs for 8 and 10 mm bolts respectively, but the reference describes a 4 versus 6 bolt configuration. The 930 bolts are 10 mm and there are 6 of them - My maintainance manual is in German, but I think the translation is for 60 ft-lbs.
Just looking for clarification. Thanks |
||
04-16-2004, 07:26 AM
|
|
|
Registered
Join Date: May 2000
Location: Los Alamos, NM, USA
Posts: 6,044
|
How are you measuring the screws; a 10 mm screw will be approximately 10 mm in diameter across the threads. 60 ft-lbs for the 10mm screws and 36 ft-lbs for the 8mm screws. If you have replaced the screws ensure you have class 12.9 (look for small characters on the edge of the head) replacements. Jim
Last edited by Jim Sims; 04-16-2004 at 07:35 AM.. |
||
|
04-16-2004, 07:30 AM
|
|
|
Registered
|
They are 10 x 60 mm replacement bolts I ordered from Pelican
|
||
|
04-16-2004, 07:35 AM
|
|
|
Registered
Join Date: Aug 2002
Location: Galivants Ferry, SC
Posts: 10,550
|
60 ft-lbs for the 10's ....
--Wil Ferch
__________________
Wil Ferch 85 Carrera ( gone, but not forgotten ) |
||
|
04-16-2004, 09:36 AM
|
|
|
Registered
|
Thanks to all
|
||
|
04-16-2004, 11:01 AM
|
|
