|
|
|
|
| Author |
|
|
Registered
Join Date: Aug 2001
Location: San Diego CA
Posts: 697
|
Routing sparkplug wires after a heater backdate 3.2
After backdating my heat on a 3.2 I found the BERU sparkplug wires could be shorter to
reach the sparkplugs or wish there was better way to route them so they're out of the way. I looked into cutting the 3 wires on the right side of the engine but you need a special tool and beru threaded crimps. The only other option was to re-route them. It took a few brackets and some cable separators from my old set of wires. They're tightly secured and I also added additional insulation. Below are some pics.      
|
||
03-06-2007, 12:25 PM
|
|
