Search Function - Where did it go?
 

Is something up? I'm looking for the usual search buttons at the top of the page and can't find them. Am I going blind? Or did you change something Wayne?

I'm trying to re-install my clutch and transmission and I'm a little concerned about these threaded rivets Haynes refers to. Unfortunately when I separated the trans and engine per the Pelican tech article (Doesn't mention these rivets and spacers) I didn't pay any attention in this area. Are these spacers and preload of the pressure plate necessary to re-install the trans to the motor?? Can re-installation be done without this preload?
As always thanks for your wisdom...

------------------
78 3.0L/3.2L CIS 911SC

Yeah, I was just looking for it too... I was like, I know there was one here, or am I just trippin???

Hey!

Hmmm.....it has gone. I used it last night, where is it now???

------------------
'75 911S Targa
'81 BMW Alpina C1 2.3
http://member.aol.com/asaffery/my911s.html

David,

That 'preload procedure' in Haynes ONLY APPLIES TO '70-'71 clutches!!!

Unbelievable how many people have been mislead by that entry in Haynes!

------------------
Warren Hall
1973 911S Targa

Wayne gives his reason in this post:

http://www.pelicanparts.com/ultimate/Forum3/HTML/009372.html

------------------
Jeff
1976 911S