![]() |
|
|
|
Registered
|
![]()
I am looking to swap my 2.7 for 3.0 or 3.2. witch would be the beter hp/U$/instalation for me?
And how much would I pay for a good 3.0 and 3.2? tks for any advice... |
||
![]() |
|
Registered
Join Date: Jul 2000
Location: Central Kentucky
Posts: 3,686
|
![]()
I would check the Rennlist site classifieds for engines and prices - there always seem to be a few there.
For straight-out hp, the 3.2 offers more than the 3.0 and the Motronic fuel injection system is supposed to be better. If you wanted to save some money and don't have any emmissions requirements holding you back, you could go with a good SC motor and a pre-74 exhaust system. Only a little less hp and you might save some dough. I think either engine would make a good upgrade. In the same situation, I think I'd go with the latter, but I'm used to that engine so I'm biased. ------------------ "Everybody wants a normal life and a cool car; most people settle for the car." Chris Titus 1983 911 SC Targa 1966 Rolls-Royce Silver Shadow |
||
![]() |
|
Senior Member
Join Date: Nov 2000
Location: Stuttgart FRG
Posts: 2,307
|
![]()
Hello
late 3,0 CIS engine with early CIS exhaust Grüsse |
||
![]() |
|
Registered
Join Date: Aug 1999
Location: Hickory NC USA
Posts: 2,502
|
![]()
I have had both motors in my car.
For HP, I prefer the 3.2, I also like the FI of a 3.2 better than the 3.0. However, 3.0 is typically more reliable. Life is always difficult decissions. |
||
![]() |
|
Registered
|
![]()
Tks guys, I think I will stay with the 3.0 It should be a much easier installation (and cheaper).
Any good late 3.0 (complete) out there? |
||
![]() |
|
![]() |
Thread Tools | |
Rate This Thread | |
|