|
|
|
|
| Author |
|
|
Registered
Join Date: Sep 2003
Location: vancouver,ca
Posts: 238
|
cds problem
does anyone know how to check a cds unit while out of the car,there are three tabs,can i do a normal ohms check,or will it kill the ohmeter because of the stored voltage,all and any help will be greatly appreciated thanks,frank
|
||
05-31-2009, 04:11 PM
|
|
|
Registered
Join Date: Oct 2006
Location: MYR S.C.
Posts: 17,321
|
take the cover off the back. jumper point 4 (labled Cs) to pin A. remove jumper. then connect your MM ( ohms) to the same 2 points. the metter should start "counting". the resistance will get higher and higher until it reaches an open or close to it, been a while since i checked one. if your MM does nothing, the capacitor is bad. if it shows a dead short, it is bad. thats really about all i can go thru with you with out getting into it deep. try the test a few times just to make sure.
__________________
86 930 94kmiles [_  _] RUNNING:[__] NOT RUNNING: ____77 911S widebody: SOLD88 BMW 325is 200K+ SOLD 03 BMW 330CI 220K:: [_ _] RUNNING: [__] NOT RUNNING:01 suburban 330K:: [_ _] RUNNING: [__] NOT RUNNING:RACE CAR:: sold |
||
|
06-01-2009, 03:56 AM
|
|
