Removing windshield trim without damaging Al trim?

[grahamkissack]

I'm going to replace my very cracked and bad condition SC's windshield trim. I've read all posts that fully cover the installation part....but how do I cut the old trim prior to removal so I dont damage the aluminum trim piece when I push out the window...pics? Thanks

[BK911]

Use a razor and cut at a 45^ angle along both sides of the trim piece. That will allow the trim piece to lift right up without exerting any force on it. If it does bend a little bit, reform it using the bare windshield as a template.

Pretty easy job.

Have fun!

[Bob Kontak]

The trim can be bent a whole lot before it is ruined. There is more risk of scraping the finish on the strips with the razor than bending it beyond repair.

I never tried this but there may be a benefit to warming (softening) up the seal with a hair dryer, heat gun or warm water before cutting to improve your control.

The windshield seal is one of the easiest "big" jobs to do on a 911. Have a pal help on the install.