|
|
|
|
| Author |
|
|
Registered
|
tach signal for data logger
Installing a data logger and need to source good tach signal ( Racepak). Can I just pigtail off the back of the tach itself? Car is 3.2 motronic mid 80's variety. The signal requirement is 50% duty cycle, 5-18 volt square wave signal ( whatever that means)
Hoping a more technically savy pelicanite could point me in the right direction. thanks Willy
__________________
[B]Willy 79 V3R5 turbo body Race Car 2013 Audi A5 quattro 2011 Tundra |
||
07-11-2011, 05:55 PM
|
|
|
Registered
|
|
||
|
07-12-2011, 06:59 PM
|
|
|
porsher
|
Pull the tach out of the dash and (I am 99% sure!) you splice into the black/violet wire which is pin 21 on the DME.
Worked for my LM-1
__________________
86 911 Race Car, with a few 993 bits in the boiler room 79 928 Race Car 88 928 Becoming a Race Car |
||
|
07-13-2011, 06:51 AM
|
|
1968 Porsche 912
