|
|
|
|
|
|
On Tour
Join Date: Apr 2010
Location: New Mexico
Posts: 1,506
|
Coil advice.....
Can I use either of the coils show below as a replacement to the stock coil on my 1988 3.2 without any other modifications?
Pelican Parts.com - MSD Blaster High Vibration Coil Pelican Parts.com - Pertronix Flame-Thrower Coils Thank you in advance Mike
__________________
- 2018 Cayenne S 958.2 - 1988 Carrera 3.2 Coupe Marine Blue (SOLD) |
||
|
|
|
|
Registered
Join Date: May 2002
Location: St Louis
Posts: 4,211
|
__________________
Rick 88 Cab |
||
|
|
|
|
Registered
|
I have the MSD blaster on my 78SC, The PO put it there, in the 9 months and almost 10K miles of ownership, I have not had an issue with it yet. I dont know how long it was on there for the PO but my guess is a while so it most likely had in the range of 20K-30K miles on it.
Regards Dave
__________________
'78 911SC Targa (Back In Action!) '00 996 Carrera (New kid on the block) '87 944 (college DD - SOLD) '88 924s (high school DD - Gone to a better home) |
||
|
|
|
|
On Tour
Join Date: Apr 2010
Location: New Mexico
Posts: 1,506
|
Quote:
__________________
- 2018 Cayenne S 958.2 - 1988 Carrera 3.2 Coupe Marine Blue (SOLD) |
||
|
|
|
|
Chain fence eating turbo
Join Date: Dec 2008
Location: Austin, TX
Posts: 9,142
|
Quote:
Not sure about the Pertronix. Be safe and use Bosch only.
__________________
Cory - turbo'd '87 C3.2 Guards/Blk, 3.4, 7.5:1 CR, 993SS cams, Borg-Warner S366 turbo @ 1.2-1.5 bar, Treadstone full bay IC, 70mm TB, TiAL F46 WG, HKS 1 1/2" BOV, twin 044 pumps, MicroSquirt AMP'd w/GM smart coilpack, Bilstein coilovers, Tramont replica Speedlines (285's rr, 225's frt), Big Reds frt, 993 rr., tower brace, MOMO wheel |
||
|
|
|
|
On Tour
Join Date: Apr 2010
Location: New Mexico
Posts: 1,506
|
Quote:
regards, Mike
__________________
- 2018 Cayenne S 958.2 - 1988 Carrera 3.2 Coupe Marine Blue (SOLD) |
||
|
|
|
|
|
Chain fence eating turbo
Join Date: Dec 2008
Location: Austin, TX
Posts: 9,142
|
The coil needs a resistor IIRC. Those coils will burn up the circuitry in the DME from what is stated here on Pelican from said experts.
__________________
Cory - turbo'd '87 C3.2 Guards/Blk, 3.4, 7.5:1 CR, 993SS cams, Borg-Warner S366 turbo @ 1.2-1.5 bar, Treadstone full bay IC, 70mm TB, TiAL F46 WG, HKS 1 1/2" BOV, twin 044 pumps, MicroSquirt AMP'd w/GM smart coilpack, Bilstein coilovers, Tramont replica Speedlines (285's rr, 225's frt), Big Reds frt, 993 rr., tower brace, MOMO wheel |
||
|
|
|
|
Registered
Join Date: Jun 2006
Location: Mendham Township, NJ
Posts: 581
|
But Pelican was recommending the MSD coil with the stock system for my 85 3.2. I just went through this last week.
__________________
2007 GT3 Red, 2008 Cayman S Track Car, 1970 911T Tangerine, 2019 AMG E53 4, 2020 S450 2019 F350 King Ranch R Gruppe Member #626 Last edited by minoclan; 01-31-2012 at 03:20 PM.. |
||
|
|
|
|
Chain fence eating turbo
Join Date: Dec 2008
Location: Austin, TX
Posts: 9,142
|
Not on a 84-89 Motronic.
|
||
|
|
|
|
Registered
Join Date: May 2002
Location: St Louis
Posts: 4,211
|
I'm pretty sure the My Spark Disappears (MSD) coil is for a Capacitive Discharge ignition and is meant to be more of a transformer than an energy storage device.
__________________
Rick 88 Cab |
||
|
|
|