Need Tail Light Help

[75-911S]

My car (1976) was severely fire damaged in the engine compartment. I have replaced both the main and the engine wiring harnesses and everything has been working fine up to now (i.e. horn, all dash lights and instruments, front parking lights and turn signals, etc.) However, I'm at a loss as to how to connect the tail light assemblies I purchased to replace the burned-up ones. Can anyone streer me to a guide on how to connect these assemblies. I can obviously tell how to connect the six pin male connectors on the tail lights to the six pin female connectors that comes from the main wiring harness. But I'd like to know where each of the following wires connect:
1. A small gauge grey and a small gauge brown wire that are together in a single sleeve and have very tiny bayonets connectors on their ends
2. Two large gauge brown wires and a smaller yellow wire contained in a single bundle and tied together with a circular connector on their end (like a bolt would go through)
3. A small gauge yellow and a yellow w/red stripes pair of wires in a single sleeve - with missing end connectors

I'm real close to getting this car back on the road and would really appreciate some help AGAIN.

Jack

[Bob Kontak]

I know there are several tail light connection posts but don't have time to search now. Go to the advanced search and load in "tail light connections" and then isolate on this forum.