Pelican Parts Forums
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Pelican Parts Forums (http://forums.pelicanparts.com/)
-   Porsche 911 Technical Forum (http://forums.pelicanparts.com/porsche-911-technical-forum/)
-   -   Is my transmission falling off? There are no dumb questions. . . (http://forums.pelicanparts.com/porsche-911-technical-forum/793766-my-transmission-falling-off-there-no-dumb-questions.html)

JJ 911SC 01-29-2014 03:09 PM
Quote:
Originally Posted by Jerome74911S (Post 7882547)
Having the concave side up on the engine mount is the position recommended by smart people on this forum (could one of them have been Grady Clay?), whereas concave faces the rubber on the transmission, according to the same recommendation. There is discussion on this point.

The PET for my car is not clear as to position of that washer.
Bonne Chance with that one :D

It make sense that the out side of the washer touch the rubber to create some pre load compression.

IIRC, there was a TB on that reversing the washer from the previously believed correct possition but that did not change some people opinion...

JJ 911SC 01-29-2014 03:40 PM
Here are a few opinions from both side of the washer...

https://www.google.ca/search?q=porsche+tb+for+transmission+concave+washe r+site:forums.pelicanparts.com&client=safari&rls=e n&biw=1436&bih=723


All times are GMT -8. The time now is 07:12 PM.
Page 2 of 2 « Prev 1 2
Show 40 post(s) from this thread on one page

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website


DTO Garage Plus vBulletin Plugins by Drive Thru Online, Inc.