|
|
|
|
| Author |
|
|
Registered User
|
A-Arm Retaining Plates
Does anyone have a picture of them installed? I'm for some odd reason having a hard time aligning the front/center bolt.
Thanks |
||
02-28-2016, 05:57 PM
|
|
|
Member 911 Anonymous
|
Please post a pic of what you are trying to do.
__________________
'85 Carrera Targa Factory Marble Grey/Black * Turbo Tail * 930 Steering Wheel* Sport Seats * 17" Fuchs (r) * 3.4 * 964 Cams * 915 * LSD * Factory SS * Turbo Tie Rods * Bilsteins * Euro Pre-Muff * SW Chip on 4K DME * NGK * Sienes GSK * Targa Body Brace PCA/POC |
||
|
02-29-2016, 06:36 AM
|
|
|
Registered User
|
Pictures below show how I installed them. But it doesn't seem right to me
 Also. I was rebuilding the front end. And these two parts are left over? I remember removing them but can't remember where they go to save my life  
|
||
|
03-06-2016, 08:11 AM
|
|
|
Registered
Join Date: Aug 2008
Location: sectors R&N, SE Pa
Posts: 3,117
|
There's supposed to be a spacer under the bar and on top of the plate. item 7 in fig.
Otherwise, it looks fine. The bushings in your last pic almost remind me of a steering rack part -did you have that down? 
__________________
Dan '87 Targa Carrera 3.2 - Fabspeed Cat Bypass, M&K Muffler, SW Chip Venetian Blue |
||
|
03-06-2016, 10:51 AM
|
|
|
Registered
Join Date: Aug 2008
Location: sectors R&N, SE Pa
Posts: 3,117
|
shot from my 87 - you might be able to see the spacer I'm talking about.
If you have installed on yours, no worries. 
__________________
Dan '87 Targa Carrera 3.2 - Fabspeed Cat Bypass, M&K Muffler, SW Chip Venetian Blue |
||
|
03-06-2016, 10:58 AM
|
|
|
Registered User
|
I have them installed on the other side of the A arm plate. Thanks for the photo!! Life saver
|
||
|
03-06-2016, 11:30 AM
|
|
|
Marble Grey
