loose wire at back of 911 engine

[BasRottier]

Hello,

Hello,

I had someone revise my 1982 911 3.0sc engine. AFterwards, I noticed a single wire apparently to be disconnected. It is near the throttle and tire-wrapped to the other cables. Anyone some ideas?
Thanks
Bas

[boyt911sc]

Bas,

Could you try another shot? Get something with better focus so we could identify this mysterious wire. Send a PM to Timmy2 (Dennis P.) he's very familiar with these engine wire harnesses.

Tony

[Flat6pac]

I don't know about the wire, but I do like the bottle cap.
Bruce

[arbita1]

I think that goes to the temp sensor in the breather cover for the warm up enrichment. It's going to be a pain to get to that. You'll probably have to take the rubber boot off the CIS.


Sent from my iPhone using Tapatalk

[timmy2]

Originally Posted by arbita1

I think that goes to the temp sensor in the breather cover for the warm up enrichment. It's going to be a pain to get to that. You'll probably have to take the rubber boot off the CIS.


Sent from my iPhone using Tapatalk

That would be my first choice.

[BasRottier]

thanks guys for the prompt responses! I'll check tomorrow
Cheers from Belgium!