Bitz 'like" EFI O2 sensor ques.

[targa44]

Just installed used EFI system and was arranging and separating sensor wires and needed to disconnect (via connector) the O2 sensor to clean up the area. After reconnecting, I tried to re-calibrate the LC-1. I couldn't... error message essentially said it was dead.
I didn't disconnect the battery to do that - how likely is it that I killed it?
thanks,

['76 911S 3.0]

Did you depin the connector or simply unplug and plug the sensor back in?

Sounds like you may need to call Innovate's tech support line...

[targa44]

Hi Jayson,

.... just unplugged and reconnected. However, I've moved on and purchased your AEM 4110 controller/gauge unit (I know you mentioned the 30-0300, but this was a good price for the 4110). I couldn't find the "gauge pod" on the AEM site that you'd mentioned. Is that something you could point me to?

Are you still with AEM?... I thought you used to have that in your signature.

thanks,