WTB: 11"/turbo/RSR steel rear flare sections

[70SWT]

Have a pair of 11" rear (turbo/930- or RSR-width) steel flares that are rusted at the edges, or perhaps bent in the rear, such as from a rear-end collision?

If so, you would have exactly what I need. I need sections to use as patch panels to fill in the spaces where the 930S-type brake vents were on a pair of 11" flares I have. The needed area from each side is above the torsion bar hole as in the pic. Of course, the needed sections could not be from a car with the brake vents; I need solid/unbroken sections.

(Yes, I know I could buy complete new steel flares from Dansk etc. and cut out the needed sections, or, given the complex curves of that area, have sections made from fresh sheetmetal by someone good with an English wheel; I am saving those options for later, as I am in no rush).

Thanks

[Winter911]

I’m on the same boat, also on a ‘72.
Hope this helps if you can’t find flares

[louielargo]

I have about 3 or 4 pairs.
PM me and Ill send pics and prices.

Cheers, Louie

[boosted79]

Do either of you have the brake vents that were cut out? I may be interested in a pair.

[70SWT]

Originally Posted by boosted79

Do either of you have the brake vents that were cut out? I may be interested in a pair.

boosted79 - yes; I sent you a PM with my contact info - cheers, Al