912 Torque specs
 

I have a 912 (67) total rehab. in process. I bought 2 books and have lots of info and techniques with 911 data but no Torques specs for the 4 cylinder. I had the block, crank, rods and flywheel machined and assembled but need data for the sleeves, heads, etc. Source?
tx,
michael

orange book, pg. 234. , or Dave's Pages here
Torque Values for Bolts and Nuts

That's the ticket!

Thanks,
Michael

Michael, some of the gland nuts that hold the flywheel on are made of a higher strength material, so check with the supplier on the flywheel bolt. I think some may be up around 350 ft lbs to 400.