|
|
|
|
| Author |
|
|
Michael t
Join Date: Oct 2009
Location: Texas
Posts: 5
|
912 Torque specs
I have a 912 (67) total rehab. in process. I bought 2 books and have lots of info and techniques with 911 data but no Torques specs for the 4 cylinder. I had the block, crank, rods and flywheel machined and assembled but need data for the sleeves, heads, etc. Source?
tx, michael |
||
11-02-2009, 07:41 AM
|
|
|
Registered
Join Date: May 2006
Location: Tampa,FL
Posts: 134
|
orange book, pg. 234. , or Dave's Pages here
Torque Values for Bolts and Nuts |
||
|
11-02-2009, 01:55 PM
|
|
|
Michael t
Join Date: Oct 2009
Location: Texas
Posts: 5
|
That's the ticket!
Thanks, Michael |
||
|
11-04-2009, 11:25 AM
|
|
|
Registered
Join Date: Jun 2006
Location: Virginia Beach
Posts: 556
|
Michael, some of the gland nuts that hold the flywheel on are made of a higher strength material, so check with the supplier on the flywheel bolt. I think some may be up around 350 ft lbs to 400.
__________________
Rusty 71 911E 55 PreA speedster 85 Turbo look Cab 62 Twin Grille Roadster (getting close) |
||
|
12-11-2009, 12:56 PM
|
|
