what parts go to machine shop

[914curt]

If I was going to decide to rebuild this engine of mine what parts do i have to send ot the machine shop, and where is a good place t send it ot to. i think that i am going to tear it down and rebuild it, start over that way i know what i have not guessing at everything because i don't know what the last guy did.

Curt

[Zeke]

Heres's what I sent. This sort of adds to my thread about money spent.
Case, decked, shuffle pinned and oil galleys drilled and tapped
Crank and rods, crank ground and polished, rods rebuilt and rebushed
Flywheel, lightened and doweled to crank
Cylinders, bored to fit new pistions
Heads, completely rebuilt with all new seats, valves, CC'd, etc.
Everything balanced.

[Dave at Pelican Parts]

Shuffle pins aren't needed on a street 914 motor. Unless you're turning very high revs or otherwise making really massive power, the case doesn't move enough to make it worthwhile.

The rest of that list sounds pretty good to me.

Curt, if you're in IL you might give Brad Mayeur in East Peoria a call. (Look him up, he's in the 309 area code I think.) He has a lot of 914 resources, and he's a good guy to have on your side. It's always nice to have someone local to talk to.

--DD