|
|
|
|
|
|
Registered
|
Vacuum Hose for Blower Motor ('86 944)
Okay. I cannot find where this should connect to. We have the blower motor in the car, the windshield wipers installed and all ready to go. But the vacuum hose that goes between the two control valves (one on each side of the blower) come together at a Y junction. I don't have any other loose vacuum lines that I can see. The PET diagram is a little sketchy since I cannot see where items #9 are in relation to the rest of the car. Any help here?
Here's the pic. Green is the vaccum line I have. But at the Y-junction, the blue hose is unknown to me.
|
||
|
|
|
|
Registered
|
anyone ever figure this one out??
__________________
was: '85 300 ZX, '87 944 NA is: '90 944 s2 coupe |
||
|
|
|
|
Registered
|
pschaars951: I recently replaced the vacume lines in the blower area. On my 85/2 na, that t-fitting had a hose going straight down maybe about an 1 inch and attached to a fitting right below it. I'll take a look tomorrow night to see if it was attached to hard fixed metal vacume line or what and upload a picture.
__________________
- 1985/2 944 Alpine White, Fuchs Musik Stadt chapter of PCA |
||
|
|
|