![]() |
|
|
|
Registered
Join Date: Sep 2009
Location: Newnan, Ga.
Posts: 69
|
![]()
The engine wiring harness I am putting in my to be spec car does not have the speed and reference sensors labeled. How do I tell which plug goes to which sensor? I am not smart enough to understand exactly what it says in Clark's garage explanation.
Its a 1984 harness. Thanks! RW
__________________
1989 911 Carrera Cabriolet Black SW Chip, M&K Pre-muffler and 1:1 Muffler 1983 944 Spec project car RIP |
||
![]() |
|
Registered
Join Date: Sep 2005
Location: new york
Posts: 1,372
|
they should have a b and d marked on them match them to the trigger bracket...or just plug them in if the car doesnt start switch them lol
|
||
![]() |
|
Registered
Join Date: May 2009
Location: Hawkinsville / Perry, Ga.
Posts: 1,239
|
You have a 50 / 50 chance of getting the plugs right the first time around. Watch the TACH Gage Needle when you try to start the engine and if you get a 1/16" needle bounce you lucked out and the engine should start. No bounce, swap the plugs around and try again.
Cheers, Larry |
||
![]() |
|
![]() |
|
Tags |
reference , sensor , speed |