|
|
|
|
| Author |
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
FS: 355mm Brembo brake kit $990 for 951S cars
Yes, that's correct; below cost. I developed these a few years ago and have sold off all sets but one.
355mm Stoptech cross-drilled racing rotor bolted to a Brembo-assisted/manufactured Custom 951S hat. DOES fit with S4 calipers as spacer kit and longer bolts are included. DOES require an 18" wheel with an 18" wheel center as your caliper will sit more than an inch further out. I have this kit on my street 951S and on my race 928 race car (S4 brakes & suspension). NEVER had a single issue, never even changed pads as heat dissipation is amazing with 4" ducting. Hitting 155mph into turn 1 at TWS and braking down hard to 80-90. Fun stuff. Will ship for that price. A few nicks here/there from being stored and some slight surface rust coloration that will be scotchbrite'd away, but otherwise NEW and uninstalled. Requires 5minute bandsaw or band sander modification on your brake pads to fit deeper into caliper. Installation is as follows: 1. Remove caliper, rotor. 2. bend back brake dust hat by hand all around. 3. Install new rotor & retaining M6 screws 4. Install new caliper via new laser-cut aluminum spacers and new longer bolts 5. Notch pads and insert into caliper 6. install X-pad retaining clip upside down 7. Install heat-sink/spacer atop of pads, and pinch x-pad retaining clip back in place. You're done. PM me if interested.   
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
05-04-2016, 11:52 AM
|
|
|
Architecture & Porsche's
Join Date: Jan 2006
Location: Austin, Texas
Posts: 3,189
|
Yes, last picture is a standard S4/TurboS front caliper with my 355mm kit on it: 5 years now, wonderful...fade-free
 Mark
__________________
Porsche Club Racing National Scrutineer '89 Andial 951 '82 928R '74 911 RSR 3.6 |
||
|
05-05-2016, 06:32 AM
|
|
