|
|
|
|
| Author |
|
|
Registered
|
Renegade nose cut scraps.
Doing some reconstructive surgery on an 81 911SC. I replaced the front nose panel and the upper cross panel and battery box with JP group stuff but I need the piece that gets cut out for the lower radiator mount on a Renegade Kit. Fits between the front suspension mounts and the nose panel on the underside of the nose. If someone has this panel still please let me know. Thanks!
|
||
04-12-2024, 06:47 PM
|
|
|
Registered
|
After reading my post I think I need to clarify that I don’t want the renegade part, but need the factory piece that gets cut out.
|
||
|
04-12-2024, 06:49 PM
|
|
|
Registered
|
Could you post a picture? If it's the part I am thinking, they should sell that part new for a small amount.
|
||
|
04-13-2024, 04:57 AM
|
|
|
Registered
|
|
||
|
04-13-2024, 11:31 AM
|
|
|
Registered
|
Thanks for the reply Koilnzel. Trying to fill in where my hand is. You can buy a whole or partial front suspension pan with this part but seems a waste just to get this one little area. Will probably just form some sheet metal into place if I can’t find the original bit.
|
||
|
04-13-2024, 11:38 AM
|
|
|
Registered
|
The sheet metal would be cost-effective if done correctly. The thread below pretty much closes that area with an rsr oil cooler mod. While you have a little more open space, it should still be doable. Theres also a company that sells premade cuts for that mod for about $100~300 if I recall correctly.
https://forums.pelicanparts.com/porsche-911-technical-forum/1023156-front-oil-cooler-duct-mod.html |
||
|
04-15-2024, 06:57 AM
|
|
|
