993RS side skirt details

[Bill Verburg]

Here's the parts



And some detail shots

[Brother]

fiberglass or metal?

[yasir]

Bill,
any chance these would fit a 964 Turbo ?
Thanks

[Don Plumley]

I genuinely doubt it - not without enough rework to make doing it with factory parts a waste. IMHO

[Bill Verburg]

Originally posted by Brother
fiberglass or metal?

neither, the factory ones are some sort of semi-flexible plastic

[Bill Verburg]

Originally posted by yasir
Bill,
any chance these would fit a 964 Turbo ?
Thanks

Like Don said, I doubt it.

[yasir]

I am kinda leaning towards buying a 993 as a DD and if i ever do that you can bet 1)-i am replacing the gears and 2)-i am buying these side skirts...
Bill you got a PM..

[john_colasante]

Bill, did you make that guard piece in the rear? What material? It's not on the parts list.

[Bill Verburg]

You also need 2 of these, they are on the wheel well parts page not the side skirt page

[john_colasante]

You didn't by any chance make a template of that piece did you? I'd just cut it out of some flexible plastic. Thanks.

[Bill Verburg]

A sheet of polyethelene and some standard plastic fasteners would do it.

I'm going to swap wheels Thrs or Fri., I'll see what I can come up w/

[john_colasante]

Hey Bill, that would be great if you can. Don't go too out of your way though. Thanks a lot.

[Bill Verburg]

Some additional shots for those currently doing this


The quarter panel holes aren't a big deal, start at the front, clip 1 or 2 of the snaps in place and mark where the holes are needed