|
Whiled overboost at 4k
Hi guys 
Car's been off the road for 5 months so had no updates until now.
An Omex 710 ECU has been installed with all new wiring etc etc by a local specialist to replace the Microsquirt that I installed which just was never quite 100%. Now the car is setup and runs fine with the new ECU, but on the dyno as it pass's 4000 rpm the boost spikes and keeps rising to 1bar +
Hardware :
3.0 SC motor
3.0 heads (ported)
RS cut valves
993 Cams
3.2 intake manifold
Full bar IC
Tial 46mm WG with 0.5bar spring
OBX headers
K27-7200
BOV
Omex 710 ECU with coil packs
I have gone through various configurations and upgraded the hardware to the above spec over the last 3+ years and have never had this issue before, yeah it would creep a bit, but to 0.6 or 0.7.
The guys installing the new ECU and wiring have gone over the setup, removed the WG and checked it, that's all fine.
Has any one got any ideas as I've run out ans the guys installing are starting to scratch there heads 
Thanks
Ah, best put a pic 
__________________
1980 SC Flatnose, Euro 3.0, LW Flywheel, 993 Cams, Port & Polish Heads, RS Cut Valves, Magnacor Leads, Boxster Brakes, WEVO Mounts, TRG Roll Bars, Rollcage, RSR rear fenders, WEVO Shifter, K27 7200 Turbo, OBX Headers, Tial Wastegate, Omex 710 ECU, 3.2 Intake, Full Bay Intercooler.....400HP
Last edited by gavinc69; 05-11-2018 at 11:42 AM..
|