[fasteddie313]

I have the MicroSquirt..

I put the VR+ connection to pin 7 of the ignition control unit and it runs on the FP circuit..

I put my test light on it while cranking and if I start cranking right away when the FP is priming it will start and the FP power circuit stays on.

But, if I turn the acc on, pause until the FP stops priming, and then crank, it will crank all day and never put power to the FP circuit...
So I just have to flip through the key and start it..

Thank you both very much for the replies..
I should probably try hooking my laptop up now and see what it says..