[fasteddie313]

With the VR+ on the pin 7 it keeps my FP relay going but gives no tach, it's just zero/dead..
With the VR+ on the coil - I get like a static RPM signal that bounces around from 10-200, does not rise with a throttle blip, fuel pump kicking in and out I think due to it falling below the 50 RPM cranking setting I put in..

Are their settings I can use to make it work? Try something else?

I have the wideband working with MS, the CLT, TPS, and the MAP all working and calibrated..
I would like to get my MAP in psi or bar rather than kpa but I haven't figured out how yet..

It took me a while to get this far. I finally figured out how to flash the firmware after trying with the tunerstudio 100 times and fighting the serial adapter I thought was causing it..

The injector dead time/pwm window was different than the frankencis manual..
I don't think it gave me any boxes to adjust the DRP like in the manual..
I did set the previous one to DPR and I think the injector dead time/pwm indicated it but didn't have the options..